Materials: 
13 Pkgs. Flower Spacer Mix (#15369) Qty:  
2 Pkgs. Jonquil 6mm Swarovski (#16544) Qty:  
1 Pkg. Light Amethyst 6mm Swarovski (#16556) Qty:  
1 Pkg. Clear Lined Strawberry Seed Beads (#J-781) Qty:  
1 Pkg. G/P Crimp Beads (#50045) Qty:  
1 Pkg. European Hinged G/P Ear Wires (#50005) Qty:  
1 Pkg. 2" Thick G/P Head Pins (#50585) Qty:  
1 Pkg. G/P Lobster Clasps  (#50137) Qty:  
1 Spool Softflex (#49106) Qty: 

Directions:       
Necklaces: 
Step 1- 
Mother's Necklace - Cut an 18" piece of Softflex. 
Daughter's Necklace - Cut an 14" piece of Softflex 
String Softflex through one crimp bead, loop through jump ring of Lobster Clasp, then back through the crimp bead.  Using a crimp tool, crush the crimp bead and trim the end.

Step 2- 
*Use the yellow and the darker pink flowers for the Mother's Necklace with the Jonquil Swarovskis. 
String the following beads: 
Seed Bead 
Jonquil Swarovski 
Yellow Flower 
Darker Flower 

Repeat this sequence approximately 33 times and end with a Seed Bead 

Step 3- 
Loop through the jump ring, back through the crimp bead, crush your crimp and trim end. 

*Use the White and the lighter pink flowers for the Daughter's Necklace with the Light Amethyst Swarovskis 
String the following beads: 
Seed Bead 
Lt. Amethyst Swarovski 
Pink Flower 
White Flower 
Pink Flower 
White Flower 

Repeat this sequence approximately 16 times and end with a Seed Bead 
 
Step 3- 
Loop through the jump ring, back through the crimp bead, crush your crimp and trim end. 
Finished Length for Mother's Necklace is approximately 15 ½ to 16 Inches. 
Finished Length for Daughter's Necklace is approximately 12 ½ to 13 Inches. 

Earrings: 
Step 1- 
String the following beads on your head pin: 
Mother's Earrings: Seed Bead, Swarovski, Yellow Flower, Pink Flower - repeat this sequence 3 times

Daughter's Earrings: Seed Bead, Swarovski, Pink Flower, White Flower, Pink Flower, White Flower, Seed Bead, Swarovski, Pink Flower, White Flower 
Step 2- 
Using wire cutters, cut off the excess head pin leaving approximately 3/16". Using flat nose pliers, bend the 3/16" piece of wire 90°. Carefully bend the 3/16" piece of wire into a loop, but don't close it tight. Insert your European Hinged Ear Wire into the loop on your head pin and now close tightly so there are no gaps. Repeat all the above steps for the second earrings.

Enjoy!