Materials:  
1  Silver plated steel bracelet (#50096) Qty:  
1 pkg.  20 1" Thick silver plated head pins (#50584) Qty:  
1 pkg.  100+ Silver plated jump rings, 4mm (#50040) Qty:  
1 pkg.  10 Orchid purple rounds,  4mm  (#22058) Qty:  
1 pkg.  10 Tanzanite Swarovski Cubes  (#16711) Qty:  

Directions:        
Step 1:  
Add head pins to all Tanzanite Swarovski Cubes and Orchid purple rounds. Onto an head pin, first place your bead. Using a wire cutter, cut off the excess head pin leaving approximately 3/16".

Using a flat nose pliers, bend the 3/16" piece of wire 90°. Carefully bend the 3/16" piece of wire into a loop and close it tight.

Step 2: 
Now lets add the cubes and rounds to the bracelet links.  Open one jump ring add the fourth link the bracelet and one head pin with a Orchid round.  Open another jump ring add one head pin with Tanzanite cube and the next link of the bracelet.  Repeat the pattern of one Orchid round, one Tanzanite cube, and one skipped link.  This will leave three empty links at the end of the bracelet.

Enjoy your new bracelet!