Materials:     
1 pkg.  Green and Aqua Crystals, 8mm (#16161) Qty:  
1 pkg.  Emerald Crystals, 4mm (#16111) Qty:  
1 pkg.  G/P Rounds, 3mm (#14018) Qty:  
1 pkg.  G/P Thick Eye Pins (#50593) Qty:  
1 pkg.  G/P Jump Rings, 4mm (#50039) Qty:  
1 pkg.  G/P Kilt Pins (#50069) Qty:  
2          Four Leaf Clover Charms (#60702) Qty:  
1          Victorian Heart Charm (#60044) Qty:  

Directions:     
Step 1:  Open a jump ring, insert the loop end of an eye pin and a Four Leaf Clover Charm and close.  Onto the eye pin place one Emerald Crystal, one G/P Round, one Green and Aqua Crystal, and one G/P Round.

Step 2:  Using a wire cutter, cut off the excess eye pin leaving approximately 3/16". Using flat nose pliers, bend the 3/16" piece of wire 90°. Using a round nose pliers bend the 3/16" piece of wire into a loop, insert your ear wire and close it tight.

Step 3:  Repeat Steps 1 and 2 for a total of two eye pins with Four Leaf Clovers.

Step 4:  Open a jump ring, insert the loop end of an eye pin and the Victorian Heart Charm and close.  Onto the eye pin place one G/P Round, one Emerald Crystal, one G/P Round, one Green and Aqua Crystal, one G/P Round.  Follow Step 2 to finish this eye pin.

Step 5:  Open a jump ring, insert one Four Leaf Clover section and loop into one end ring on the kilt pin, close the jump ring.  Repeat for the other Four Leaf Clover section on the opposite end ring of the kilt pin.  Using another jump ring, place the Victorian Heart eye pin section onto the center ring of the kilt pin.  Enjoy and may you have lots of luck while wearing your sparkling new pin!