Orchid
Dangle Earrings What a fun design! Use a charm connector
to make a delightful pair of chandelier earrings. Orchid not your
favorite color? We carry over 15 other colors of round
druks ...just pick your favorite!
Materials:
1 pkg. Orchid Druks, 4mm (#22058)
Qty:
1 pkg. Orchid Druks, 6mm (#22059)
Qty:
1 pkg. S/P Bali Style Spacers (#14734)
Qty:
1 pkg. S/P Thick Head Pins (#50584)
Qty:
1 pkg. S/P Thick Eye Pins, 1" (#50592)
Qty:
1 pkg. S/P French Hook Ear Wires (#50002)
Qty:
2 S/P 3 Space Drop Connector (#60107)
Qty:
Directions:
Step 1: Onto a head pin,
place 1 Bali Spacer and 1 6mm Orchid Druk. Using a wire cutter, cut
off the excess head pin leaving approximately 3/16". Using a flat nose
pliers, bend the 3/16" piece of wire 90°. Carefully bend the 3/16"
piece of wire into a loop but don't close it tight. Insert the loop
of an eye pin into the loop and then close the loop tightly.
Step 2: Onto the eye pin, place 1 4mm Orchid Druk. Cut off the
excess pin and create a loop as described in Step 1, again without closing
yet. Insert the loop of another eye pin into the loop and then close
tightly.
Step 3: Repeat Step 2 for
another eye pin, but don't close tight yet. On the lowest, center
section of your Drop Connector, insert the loop of the eye pin and close
tightly.
Step 4: Onto the eye pin, place 1 6mm Orchid Druk. Cut off the
excess pin and create a loop as described in Step 1, again without closing
yet. Insert the loop of another eye pin into the loop and then close
tightly.
Step 5: Onto the eye pin,
place 1 4mm Orchid Druk. Cut off the excess pin and create a loop
as described in Step 1, again without closing yet. Onto one of the
end sections of your Drop Connector, insert the loop off the eye pin and
close tightly. Repeat for the opposite side.
Step 6: Open the loop of an
ear wire and insert the top hole of the Drop Connector into the loop and
close tightly. Repeat these steps for your second earring and enjoy!
|
