Materials:
1 pkg.    Red Horn Rectangles, 21X12mm  (#21406) Qty:  
2 pkgs.  Pony Beads, Ruby Mix  (#17845) Qty:  
1 pkg.    1" Thick G/P Eye Pins, 20 gauge  (#50591) Qty:  
1 pkg.    Classic Toggle,  G/P 13mm  (#50189) Qty:  
1 pkg.    Crimp, G/P 2mm  (#50045) Qty:  
1 spool   Gold Beadalon, 7 strand 0.015mm  (#49121) Qty:  

Directions:  
Step 1:  Onto an eye pin, place four varied pony beads.  Using a wire cutter cut off the excess eye pin leaving approximately 3/16". Using flat nose pliers, bend the 3/16" piece of wire 90°. Use round nose pliers to carefully bend the 3/16" piece of wire into a loop, and close the loop, tight.  Repeat 11 times.

Step 2:  Cut two 12" pieces of Beadalon.  String both strands of Beadalon through a crimp bead, make a loop through the ring toggle, back through the crimp bead, pull the loop tightly, and crush the crimp bead.  String one Pony bead onto both strands, then separate the strands.

Step 3:  String the top strand with the following:
3 Pony, 1 Eye Pin (from step 1), 2 Pony, 1 Eye Pin (from step 1),  2 Pony, 
1 Red Horn, 2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  2 Pony,
1 Red Horn, 2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  2 Pony,
1 Red Horn, 2 Pony, 1 Eye Pin (from step 1),  2 Pony, 1 Eye Pin (from step 1),  3 Pony. Top Strand is done.

Step 4:  String the bottom strand the same as the top, using the other end of the eye pins which were used for the top strand.

Step 5:  Bring the both strands together, add one Pony bead and one crimp bead.  Make a loop through the bar toggle, back through the crimp bead, pull the loop tightly, and crush the crimp bead.  Trim the ends. Finished length is 8".  Enjoy!