Materials:
1 pkg. S/S Bracelet (#50091) Qty:  
2 pkg. S/S Pudgy Spacers (#27021) Qty:  
1 pkg. S/S Corrugated Rounds (#27529) Qty:  
1 pkg. S/S 2mm Rounds (#27005) Qty:  
1 pkg. Clear 5mm Swarovski Crystals (#16503) Qty:  
4 pkg. S/S Jump Rings  (#50075) Qty:  
2 pkg. S/S Head Pins (#50110) Qty:  

Directions:
Step 1:  On each of nine head pins place a pudgy spacer, a corrugated round and another pudgy spacer.

Step 2:  Using a wire cutters, cut off the excess head pin leaving approximately 3/16". Using a flat nose pliers, bend the 3/16" piece of wire 90°. Carefully bend the 3/16" piece of wire into a loop with round nose pliers.

Step 3:  On each of eight head pins place a 2mm round, a 5mm Swarovski crystal, and a 2mm round.

Step 4:  Repeat step 2.

Step 5:  Twist open 17 jump rings and attach to loops in head pins.  Do not close.

Step 6:  Place the first jump ring with the corrugated round right next to the clasp and twist closed.

Step 7:  Place a jump ring with a crystal just to the left of the next solid spacer on the bracelet and twist closed.

Step 8:  Continue in this pattern to the left of each solid spacer on the bracelet until you end with a corrugated round.