Materials:
1 Pkg. Sherbet Cube Mix (#24088) Qty: 
2 Pkg. Silver Plated 6mm Heishi (#14704) Qty: 
1 Pkg. S/P 1" Head Pins (#50584) Qty: 
1 Pkg. S/P 1" Eye Pins (#50592) Qty: 
1 Pkg Sterling Silver Lobster Clasp (#50134) Qty:  
1 Foot Sterling Silver Oval Chain (#62001) Qty:  

Directions:
Step 1: Onto an eye pin, place 1 Bali Heishi, 1 Sherbet Cube and 1 Bali Heishi. Using a wire cutter, cut off the excess head pin leaving approximately 3/16". Using a flat nose pliers, bend the 3/16" piece of wire 90°. Carefully bend the 3/16" piece of wire into a loop but don't close it tightly.  Repeat this for five more cubes in different colors.

Step 2: With a pair of wire cutters cut the chain into 6 sections.  Each section should be an oval, a circle and an oval.

Step 3: Insert the oval of each chain section into the loops you have made in the eye pins to connect the bracelet.  Twist the loop to close the eye pin. You should have one section of chain that is attached only at one end.

Step 4: With a pair of wire cutters cut 1 oval section of the chain and insert it into the loop of the eye pin at the other end of the bracelet. 

Step 5: Twist open the jump ring on the lobster clasp and insert the single loop of chain.  The clasp will then attach to the last loop of chain at the other end. Twist the jump ring closed.

Step 6: To make the dangles: Onto a head pin, place 1 Bali Heishi, 1 of the remaining cubes and 1 Bali Heishi.  Make a loop using the directions in step 1.  Onto an eye pin, place 1 Bali Heishi, the remaining cube and 1 Bali Heishi.  Make a loop using the directions in Step 1.  Insert the head pin loop into the eye pin loop.  Attach to bracelet by inserting the jump ring from the clasp into the other eye pin loop and twisting closed.  Enjoy!