Wind Chime Earrings You're going to love the playful design of
these earrings with staggered crystals. Not wild about cobalt?
Take a look at all the other colors of crystals
1 pkg. S/S bead caps, 10mm (#27541)
1 pkg. 2" S/P head pins (#50586)
2 pkg. Cobalt fire polished crystals, 4mm (#16114)
1 pkg. S/S French hook ear wires (#50008)
1 pkg. Antique S/S flat heishi (#27503)
Step 1: Start
by making the shortest dangle of the wind chime. Get a head pin and string
a heishi bead and a faceted crystal. Using a wire cutter, cut off
the excess head pin leaving approximately 3/16". Using a flat nose pliers,
bend the 3/16" piece of wire 90°. Carefully bend the 3/16" piece of
wire into a loop and hang it from one of the loops of the bead cap.
Step 2: Make
the second dangle by stringing a heishi, and a crystal, leaving a small
space (about 1/8") on the head pin before making the loop. Hang this on
the next loop of the bead cap. Repeat the same process with all of
the other dangles, leaving a space of an 1/8" larger than the space on
the dangle before, until you complete all 6 dangles.
Step 3: String
a crystal through a head pin and put it through the bead cap (center hole),
make a loop on the other side and attach it to the ear wire. The
crystal should sit right under the bead cap.
Step 4: Repeat
the process for the other earring. Enjoy!