Materials:
2 Pkg. of 8mm Hematine Rounds (#11009-8) Qty: 
1 Pkg. of 8mm White Swarovski Pearls (#26503) Qty: 
1 Pkg. of 6mm S/S Corrugated Rounds (#27529) Qty: 
2 Pkg. of S/S Star Shaped Heishi (#27556) Qty: 
1 Pkg. of S/S Lever Back w/Tulip (#50026) Qty: 
1 Pkg. of S/S Medium 2 inch Head Pin (#50108) Qty: 
1 Pkg. of S/S Small Crimps (#50054) Qty: 
1 Pkg. of Jet Swarovski Toggle Clasp (#50282) Qty: 
1 Spool  SoftFlex Beading Wire, medium  (#49106) Qty: 

Bracelet Directions:
Step 1:  Cut an 11" piece of SoftFlex.  String SoftFlex through one crimp bead, loop through the round section of the clasp, then back through the crimp bead.  Using a crimp tool, crush the crimp bead and trim the end.

Step 2:  String the following beads: 
Hematine, Star Heishi, Pearl, Star Heishi, Hematine, Sterling Silver Round
Repeat 5 times leaving out last Sterling Silver Round.

Step 3:   String a crimp bead then loop through the chain at the end of the toggle section of the clasp and back through the crimp bead, crush the crimp and trim the end.

Finished length is approximately 8 ½ Inches.  If you desire a smaller length, just remove an 8mm Bead and a Star Heishi.  These two beads measure ¼ inch.

Earring Directions: 
Step 1:  Onto a head pin place the following beads: 
8mm Hematine, Star Heishi, 8mm Pearl, Star Heishi, Sterling Silver Round

Step 2:  Using flat nose pliers, bend the head pin 90°. Using wire cutters, cut off the excess head pin leaving approximately 3/16".  Carefully bend the 3/16" piece of wire into a loop, but don't close it tight.  Insert your Lever Back Ear Wire into the loop of your head pin and now close tightly so there are no gaps.  Repeat all the above steps for the second earring. Enjoy!!!