Materials:
1 Pkg. 6mm Silver Glass Pearls (#26014) Qty: 
2 Pkgs. Bali Bead Caps (#27507) Qty: 
1 Pkg. TR Crystal AB Seed Beads (#J-721) Qty: 
1 foot Oval & 8 Chain (#62007) Qty: 
1 Pkg. S/P Thick Eye Pins (#50594) Qty: 
1 Pkg. S/S Lobster Claw Clasp (#50134) Qty: 

Directions:
Step 1:  Cut chain into 4 sections of 3 inches each.  Open the jump ring on the clasp and slip one of the sections of chain into it.  Close tightly.  Set aside.

Step 2:  Onto an eye pin place a bead cap, pearl, bead cap and a seed bead.  Repeat this twice leaving out the last seed bead. Using flat nose pliers, bend your remaining wire 90°.  Set aside.

Step 3:  Repeat step 2 twice

Step 4:  Take one of the finished eye pins.  Using a wire cutter cut off the excess head pin leaving approximately 3/16". Carefully bend the 3/16" piece of wire into a loop, insert one section of your chain and then close the loop tightly. At the other end of your eye pin, open it up just enough to get another section of your chain in it and close tightly.  Bend this eye pin so that the center is curved.  This will be your focal section.

Step 5:  Repeat step 4 on either side of the focal section.  Do not bend the remaining eye pins.  Your Lobster Claw Clasp will fit nicely into the last section of chain.

Finished necklace is approximately 16 ¾ inches long.  If you would like it longer just purchase more chain.  Enjoy!