Materials:
1 Victorian Heart Pendant (#21230) Qty: 
2 Pkgs. 4mm White Swarovski Pearls (#26501) Qty: 
2 Pkgs. 4mm Rosaline Swarovski Pearls (#26509) Qty: 
3 Pkgs. S/S Bali Tube Bead (#27542) Qty: 
2 Pkgs. 4mm S/S Shiny Heishi (#27502) Qty: 
1 Pkg. S/P 1" Thick Eye Pins (#50592) Qty: 
1 Pkg. S/S Small Toggle (#50149) Qty: 
1 Pkg. 4mm Jump Rings (#50040) Qty: 
1 Tube of S/P Crimp Beads (#50046) Qty: 
1 Spool of Silver Beadalon  (#49122) Qty: 

Directions:
Step 1:  Take an eye pin, holding it at the eye.  Using flat nose pliers bend the wire 90°.  Carefully bend the piece of wire into a loop and insert the pendant before closing.  Adjust so the eye part is at the top of the heart, wrapping any remaining wire into the hole of the heart.  Open a jump ring and place the eye of the eye pin in it.  Close tightly.

Step 2:  Cut a 20" piece of Beadalon and string a Bali Tube, the Pendant and another Bali Tube.

Step 3:  Starting from the left side string the following beads:
Rosaline Pearl, Tube, Rosaline Pearl, Heishi, White Pearl, Tube, White Pearl, Heishi.

Step 4:  Repeat 5 times leaving out the last Heishi.  String Beadalon through 1 crimp bead, then through the toggle and then back through the crimp bead.  Snug up crimp bead to toggle.  Crush crimp bead with crimping pliers.  Cut off excess Beadalon.

Step 5:  Repeat Steps 3 & 4 on the right side.  When repeating the design repeat it completely 5 times and then string a Rosaline Pearl, Tube and a Rosaline Pearl.  Length is approximately 17 inches.  Enjoy!