Materials:
1 Pkg. Satin Seafoam Atlas Beads (#15565) Qty: 
1 Pkg. Capri Emerald Cut Rectangles (#18967) Qty: 
2 Pkgs. S/P Rounded Square Beads (#14034) Qty: 
1 Pkg. 2 in. S/P Thick Eye Pins (#50594) Qty: 
1 Pkg. S/P 6mm Jump Rings (#50036) Qty: 
1 Pkg. S/P Small Rope Toggle (#50164) Qty: 

Directions:
Step 1:  Onto an eye pin place a S/P Round Bead, a Capri Bead and a S/P Round Bead.  Using flat nose pliers, bend the leftover wire 90°.  Using a wire cutter cut off the excess head pin leaving approximately 3/16".  Carefully bend the 3/16" piece of wire into a loop and close tightly.  Repeat this step with all of your Capri beads (9 more times) and put to the side.

Step 2:  Repeat Step 1 using the Satin Seafoam beads instead of the Capri beads.  You should end up with 20 sections of designs.

Step 3:  Open a jump ring and place the loop of the toggle and the first section into it.  Close tightly.

Step 4:  Continue adding each section, alternating between the Capri and Seafoam designs, by opening a jump ring and placing the loops of each section into the jump ring.  Closing each one tightly.  Finish by adding the remaining part of the toggle clasp.

Finished length is approximately 20 inches.  Enjoy!