Materials:
1 Pkg.  Silver Plated Rounds, 3mm, 20 Pieces  (#14026) Qty: 
1 Pkg.  Silver Plated Rounds, 3mm, 100 Pieces  (#14030) Qty: 
2 Pkgs. Jonquil Czech Crystal, 8mm  (#16110) Qty: 
2 Pkgs. Light Amethyst Leaves  (#22293) Qty: 
2 Pkgs. Peridot Leaves  (#22294) Qty: 
2 Pkgs. Light Sapphire Leaves  (#22296) Qty: 
1 Pkg.  Silver Plated Jump Rings, 4mm  (#50040) Qty: 
3 Pkgs. Silver Plated Thick Eye Pins, 2 inches  (#50594) Qty: 
Tools you will need (change quantity to 1 if you need them):
Flat Chain Nose Pliers (#51016) Qty: 
Round Nose Pliers (#51017) Qty: 
Side Cutters (#51018) Qty:  

Directions:
Eye Pins: 
Step 1.  On each of 13 Head Pins, place 1 S/P Round, 1 Peridot Leaf, and 1 S/P Round.
Using a Side Cutter cut off the excess eye pin leaving approximately 3/16". Using Flat Nose Pliers, bend the 3/16" piece of wire 90°.  With the Round Nose Pliers, carefully bend the 3/16" piece of wire into a loop, and close it tightly. Repeat this for each of the other colors of Leaves.

Step 2.  Repeat Step 1 for the Jonquil Crystals, using the same pattern and substituting a Crystal for the Leaf.

Connecting the Eye Pins: 
Step 1.  Twist open a Jump Ring and insert first one loop of the Eye Pin of the Peridot Leaf and then the loop of the Eye Pin of the Amethyst Leaf.  Be sure your leaves are facing the same direction.  Twist Jump Ring closed.

Step 2.  Repeat Step 1 next connecting the Jonquil Crystal to the Amethyst Leaf, and then the Sapphire Leaf to the Jonquil Crystal.  Your pattern should be Peridot Leaf, Amethyst Leaf, Jonquil Crystal, and Sapphire Leaf.

Step 3.  Repeat this pattern until you have used all the Eye Pins that you previously prepared.  If you want the make the necklace longer, add more Eye Pins.  Enjoy!