Materials:
4 Pkgs.  Silver Plated Rounds, 4mm  (#14027) Qty: 
2 Pkgs.  Mint Czech Crystals, 6mm  (#16127) Qty: 
2 Pkgs. Aqua Czech Crystals, 6mm  (#16151) Qty: 
2 Pkgs.  Indicolite Swarovski Crystals, 4mm  (#16590) Qty: 
2 Pkgs.  Aqua Czech Druks, 8mm  (#22036) Qty: 
1 Pkg.   Bracelet Remembrance Wire  (#49037) Qty: 
1 Pkg.   Silver Plated Thick Head Pins, 1 inch  (#50584) Qty: 
1 Pkg.  Silver Plated Jump Rings, 4mm  (#50040) Qty: 

Tools you will need (change quantity to 1 if you need them):   
Flat Chain Nose Pliers (#51016) Qty:  
Round Nose Pliers (#51017) Qty:  
Side Cutters (#51018) Qty:   
Memory Wire Cutters  (#51005) Qty:  

Directions:   
To make the drops:
Step 1.  On each of the Head Pins place a Mint Crystal. Using flat nose pliers, bend the wire 90°. Using a Wire Cutter, cut off the excess Head Pin, leaving approximately 3/16". Using Round Nose Pliers, carefully bend the 3/16" piece of wire into a loop and close it tightly.

Step 2.  Twist open a Jump Ring and place the Mint Crystal drop onto the Jump Ring and twist the Jump Ring closed.  Repeat for all the drops.  Set aside.

To assemble the bracelet:
Step 1.  Cut approximately 5 loops of Wire.

Step 2.  With your Flat Nose Pliers, bend one end of the wire into a loop.

Step 3.  String 1 S/P Round, 1 Indicolite Crystal, 1 S/P Round, 1 Aqua Crystal, 1 S/P Round, 1 Indicolite Crystal, 1 S/P Round, 1 Mint Drop and 1 Aqua Druk.  Continue this pattern until you use all of your beads.

Step 4.  Snug up your beads and cut any excess Wire with your Memory Wire Cutters, leaving about 3/16” piece of Wire.  With your Flat Nose Pliers, bend the end of the Wire into a loop. Finished!  Enjoy!