Materials:
1 Pkg. Yellow Turquoise Flat Puff Squares (#11694) Qty: 
1 Pkg. Shiny Brass Heishi (#14041) Qty: 
1 Pkg. Black Rounds, 4mm (#18065) Qty: 
1 Pkg. Six-sided Black Tube Shapes (#18084) Qty: 
1 Pkg. G/P Charm Bracelet (#50095) Qty: 
1 Pkg. Thin, 2", G/P Head Pins, 24 gauge (#50581) Qty: 
Tools you will need (change quantity to 1 if you need them): 
Flat Chain Nose Pliers (#51016) Qty: 
Round Nose Pliers (#51017) Qty: 
Side Cutters (#51018) Qty: 

Directions: 
Step 1.  Onto each of 7 Head Pins, place the following:
A Black Round, a Brass Heishi, a Black Tube, and a Brass Heishi.

Step 2. Using Flat Nose Pliers bend the excess wire 90°.  Using a Side Cutter cut off the excess Head Pin leaving approximately 3/16".  With the Round Nose Pliers, carefully bend the 3/16" pieces of wire into a loop, but do not close tightly.  Set aside.

Step 3.  Onto each of 6 Head Pins, place the following:
A Black Round, a Brass Heishi, a Yellow Turquoise Square, and a Black Round.  Repeat Step 2.

Step 4.  Measure an inch from the end of your Chain and insert the open end of a Head Pin containing a Yellow Turquoise Square.  Using Flat Nose Pliers, close the loop of the Head Pin tightly.

Step 5.  Measure an inch from the Head Pin that you just attached and insert the open end of another Head Pin containing a Gemstone.  Using Flat Nose Pliers, close the loop of the Head Pin tightly.  Repeat 4 times, using the rest of these Head Pins.

Step 6.  Using the same method as in Steps 4 and 5, attach the remaining Head Pins, placing them, as you desire, in between the already attached Head Pins.  Enjoy!  The completed length of this bracelet is 7.25”.