Materials:
1 Pkg. Magnesite Fuchsia Flat Oval, 25x15x7mm  (#11717) Qty: 
1 Pkg. Sterling Silver Pudgy Spacer, 3x1.5mm  (#27021) Qty: 
1 Pkg. Sterling Silver Jump Rings, 5mm  (#50079) Qty: 
1 Pkg. Silver Plated Thick Head Pins, 2 inches  (#50586) Qty: 
1 Pkg. Silver Plated Contempo Earring  (#50214) Qty: 
1 Ft.  Sterling Silver Dot & Dash Oval Chain  (#62001) Qty: 
Tools you will need (change quantity to 1 if you need them): 
Flat Chain Nose Pliers (#51016) Qty: 
Round Nose Pliers (#51017) Qty: 
Side Cutters (#51018) Qty: 

Directions:
Step 1.  Onto each Head Pin place a Spacer, a Fuchsia Oval, and a Spacer.

Step 2. Using a Flat Nosed Pliers bend the Head Pin 90°. Using a Side Cutter cut off the excess Head Pin leaving approximately 3/16". Using the Round Nosed Pliers carefully bend the 3/16" piece of wire into a loop, but don't close it tightly.  Set aside.

Step 3. Cut your Chain to the desired length.  Ours is approximately 1 ½ inches.  Whatever length you choose, be sure to leave the small ring at either end.

Step 4.  Twist open a Jump Ring and place it in the loop of the Ear Wire and the ring of the Chain. Twist the Jump Ring closed.

Step 5.  Place the other end of the Chain into the loop of one of the Head Pins and twist closed.

Step 6.  Repeat for other earring. Enjoy!