|
Earrings:
- 2 Three Space Drops S/P (#60107) Qty:
- 2 6mm Amethyst Beads (#11001-6)
Qty:
- 6 4mm Amethyst Beads (#11001-4)
Qty:
- 26 Emerald Seed Beads (#J-716)Qty:
- 6 Thin Head Pins (#50582)Qty:
- 6 6mm Jump Rings S/P (#50036) Qty:
- 2 Sterling Flat Ear Wires (#50008)Qty:
- E6000 Adhesive (#49087) Qty:
Step-by-step Bracelet:
1. Begin by applying a small dot of E6000 to the center point
of one connector and then carefully use a tweezers to put one SL MT Emerald
Seed Bead on the glue. Set aside to dry.
2. On each eye pin, place one SL MT Emerald Seed Bead, one 6mm
Amethyst Bead and then another seed bead. Cut off the excess eye
pin (leave about 1/4") and use a Round Nose Pliers
to create a closed loop.
3. Attach each eye pin section to a connector with a jump ring
until you have the desired length.
4. Attach your Lobster Clasp using a Jump Ring on one end.
Attach another Jump Ring on the other end and you're all done!
Step-by-step
Earrings:
1. Begin by applying a small dot of E6000 to the center point
on each silver drop. Set aside to dry.
2. On 4 of your head pins, place one S/L MT Emerald Seed Bead,
one 4mm Amethyst Bead, and three more seed beads.
3. Cut
off the excess head pin (leave about 1/4") and use a Round Nose Pliers
to create a closed loop.
4. On the last 2 head pins, place one seed bead, one 6mm Amethyst,
and three more seed beads. Repeat step 3 above for each.
5. Using a jump ring, put two of the 4mm Amethyst head pins and
one 6mm Amethyst eye pin on each earring drop.
6. To add a 4mm Amethyst to your earring wires, straighten out
the loops of the ear wires, remove the silver bead, and carefully slide
on a 4mm Amethyst bead. Using a round nose pliers, re-loop the ear
wire around the drop and you're all done!
|
