Colors of Autumn Bracelet
This colorful bracelet is made with our Czech pressed glass Autumn
Cube Mix. Linked together between chain, these bold cubes make a
glorious statement on your wrist. For a variation on the colors,
you could use our Sherbet
Cube Mix. The finished length of the bracelet, with the dangle
is 9 ¾”. The length that will go around your wrist is a little
over 7 ½”. Please note, the picture shows brass heishi spacers which we no longer carry, we substitued 6mm Bali style heishi in the materials list below.
Materials:
2 Pkgs of Gold Plated Bali Style Heishi, 6mm(#14703)
Qty:
1 Pkg of Large Autumn Cubes, 9x8mm (#24130)
Qty:
1 Pkg of Gold Plated Jump Rings (#50039)
Qty:
1 Pkg of Gold Plated Classic Toggles (#50189)
Qty:
1 Pkg of Gold Plated Head Pins (#50583)
Qty:
1 Pkg of Gold Plated Eye Pins (#50591)
Qty:
1 Foot of Gold Plated Figaro with Twist Chain
(#62020) Qty:
Tools you will need (change quantity to 1
if you need them):
Flat Chain Nose Pliers (#51016)
Qty:
Round Nose Pliers (#51017) Qty:
Side Cutters (#51018) Qty:
Directions:
Step 1. Onto an Eye Pin, place 1 Heishi, 1 Cube and 1 Heishi.
Using a Side Cutter, cut off the excess Eye Pin leaving approximately 3/16".
Using Flat Nose Pliers, bend the 3/16" piece of wire 90°. Carefully
bend the 3/16" piece of wire into a loop but don't close it tightly. Repeat
this for five more cubes in different colors. Set aside.
Step 2. Onto a Head Pin, place 1 Heishi, 1 Cube, and 1 Heishi.
Using a Side Cutter, cut off the excess Head Pin leaving approximately
3/16". Using Flat Nose Pliers, bend the 3/16" piece of wire 90°. Carefully
bend the 3/16" piece of wire into a loop but don't close it tightly.
Set aside.
Step 3. Cut 6 sections of Chain. Each section should be:
an oval, a figure eight, and an oval.
Step 4. Insert an oval of a chain section into a loop of one
of the Eye Pins. Twist the loop of the Eye Pin closed.
Step 5. Repeat Step 4 for all the sections of Chain and the Eye
Pins. (Be aware of the manner in which you are placing the colors.)
Step 6. Only one end of the bracelet should have a section of
Chain hanging off it. Cut that section so that only one oval is hanging.
This oval is where you will attach the 1 Head Pin.
Step 7. Place the loop of the Head Pin into the single oval of
Chain on the end of the bracelet and twist the loop closed.
Step 8. Count up from the Head Pin, past 2 Cubes (counting the
Cube on the Head Pin). Right before the third Cube, twist open a
Jump Ring and insert the oval of Chain right under the third Cube and the
loop from one side of the Clasp. Twist the Jump Ring closed.
Step 8. Twist open a Jump Ring and insert the loop of the Eye
Pin on the other end of the bracelet and the loop from the other end of
the Clasp. Twist the Jump Ring closed. Enjoy!
|
