Materials:
2 Pkg. Topaz Swarovski Baroque Pendant (#16764) Qty: 
1 Pkg. Sand Opal Swarovski Bicone, 5mm (#16655) Qty: 
1 Pkg. Gold Plated Jump Rings, 4mm (#50039) Qty: 
1 Pkg. Thick Gold Plated Eye Pins, 1”, 20 gauge (#50591) Qty: 
1 Pkg. Gold Plated Pinch Bails (#50572) Qty: 
1 Pkg. Gold Plated Hinged Ear Wires (#50613) Qty: 

Tools you will need (change quantity to 1 if you need them):
Flat Chain Nose Pliers (#51016) Qty: 
Round Nose Pliers (#51017) Qty: 
Side Cutters (#51018) Qty:  

Directions:
Step 1.  Place a Jump Ring onto a Pinch Bail and squeeze the Pinch Bail into the hole of a Topaz Baroque Crystal Pendant.  Set aside.
Step 2.  Onto an Eye Pin, place a Sand Opal Crystal.
Step 3.  Using Flat Nose Pliers, bend the piece of wire 90°.  Using a wire cutter cut off the excess Eye Pin leaving approximately 3/16".  Carefully bend the 3/16" piece of wire into a loop, using Round Nose Pliers, and close the loop tightly.
Step 4.  Twist open the Jump Ring attached to the Pinch Bail and insert one loop of the Eye Pin.  Twist the Jump Ring closed.
Step 5.  Twist open another Jump Ring and insert the loop of an Ear Wire and the loop at the opposite end of the Eye Pin.  Twist the Jump Ring closed.
Step 6.  Repeat Steps 1-5 for the second earring.