Crystal Dragonfly Earrings
Our vintage dragonly fly charms are accented with peridot, rose, amethyst and clear AB Swarovski crystal bicone beads for a fresh look.

Materials: 
1 Pkg. of Peridot Swarovski Bicones, 5mm (#16511) Qty: 
1 Pkg. of Rose Swarovski Bicones, 5mm (#16531) Qty: 
1 Pkg. of Amethyst Swarovski Bicones, 5mm (#16551) Qty: 
1 Pkg. of Crystal Clear AB Swarovski Bicones, 3mm (#16593) Qty: 
1 Pkg. of Copper Colored Niobium Ear Wires (#50320) Qty: 
1 Pkg. of 2 inch Vintage Brass Thick Eye Pins, 20 gauge (#50327) Qty: 
1 Pkg. of Antiqued Copper Jump Rings, 6mm (#50560) Qty: 
2 Vintage Lady Dragonfly Charms (#59059) Qty: 

Tools and glue you will need (change quantity to 1 if you need them):
Flat Chain Nose Pliers (#51016) Qty:   
Round Nose Pliers (#51017) Qty:   
Side Cutters (#51018) Qty: 

Directions:
Step 1. Onto an Eye Pin, place the following:
1 Amethyst Crystal
1 Clear AB Crystal
1 Peridot Crystal
1 Clear AB Crystal
1 Rose Crystal
1 Clear AB Crystal

Step 2. Using a Side Cutter cut off the excess Head Pin leaving approximately 3/16". Using Flat Nose Pliers, bend the 3/16" piece of wire 90°. Using Round Nose Pliers, bend the 3/16" piece of wire into a loop and close tightly. Set aside.

Step 3. Twist open a Jump Ring and insert the bottom loop of your Eye Pin (the end of the Eye Pin with the Amethyst Crystal) and the loop from one of your Dragonfly Charms. Twist the Jump Ring closed.

Step 4. Twist open the loop of an Ear Wire and insert the loop at the opposite end of your Eye Pin. Twist the loop of the Ear Wire closed.

Step 5. Repeat Steps 1-4 for the second earring and enjoy!