Festive Filigree Earrings
These simple, fun earrings are a perfect combination of our vintage brass filigree, midnight blue pearls and three colors of Swarovski crystals. This is a gorgeous color palate that will compliment any outfit!

Materials: 
2 Vintage Filigree Round Half Ring Charms (#59037) Qty: 
1 Pkg. Midnight Blue Round Pearls, 6mm (#26022) Qty: 
1 Pkg. Sapphire Swarovski Bicones, 4mm (#16514) Qty: 
1 Pkg. Tanzanite Swarovski Bicones, 4mm (#16534) Qty: 
1 Pkg. Amethyst Swarovski Bicones, 4mm (#16550) Qty: 
1 Pkg. Vintage Brass Regular Loop Ear Wires (#50337) Qty: 
1 Pkg. Vintage Jump Rings, 4mm (#50332) Qty: 
1 Pkg. 2 inch Vintage Brass Thick Head Pins (#50326) Qty: 

Tools and glue you will need (change quantity to 1 if you need them):
Flat Chain Nose Pliers (#51016) Qty:   
Round Nose Pliers (#51017) Qty:   
Side Cutters (#51018) Qty: 

Directions:
Step 1. Take one Ear Wire and pry open the bottom loop with Flat Nose Pliers. Thread the loop through one of the holes lining the outer rim of the Filigree Ring. Gently close the loop with the Pliers.

Step 2. Thread a Midnight Pearl onto a Head Pin. Create a wrapped loop by grasping the Head Pin with Round Nose Pliers about 3mm above the Pearl and curving the Pin around the Pliers so it is facing downward. Using your fingers, wrap the 3mm section twice and trim excess with Side Cutters. Repeat this process with one Amethyst Bicone, one Tanzanite Bicone, and one Sapphire Bicone to create four dangles.

Step 3. Gently twist open a Jump Ring with Flat Nose Pliers and thread each of the dangles onto it. Thread the open Jump Ring through a hole in the inner rim of the Filigree Ring, directly below the Ear Wire. Close the Jump Ring.

Step 4. Repeat Steps 1-3 to create the other earring. Enjoy!