Materials:
1 Pkg. Fancy Jasper, 4mm (#11031-4) Qty: 
1 Vintage Round Face Charm (#59104) Qty: 
1 Vintage Filigree Round Half Ring Charm (#59037) Qty: 
2 Vintage Thin Ruffled Rings (#59073) Qty: 
4 Vintage Thin One-Sided Hammered Rings (#59076) Qty: 
1 Vintage Thin One-Sided Hammered Large Ring (#59099) Qty: 
1 Pkg. 2” Vintage Brass Thick Eye Pins (#50327) Qty: 
1 Pkg. Vintage Jump Rings, 6mm (#50333) Qty: 
1 Pkg. Large Vintage Lobster Claw Clasps (#50325) Qty:    

Tools you will need (change quantity to 1 if you need them): 
Round Nose Pliers (#51017) Qty: 
Flat Chain Nose Pliers (#51016) Qty: 
Side Cutters (#51018) Qty: 

Directions:
Step 1. Twist open a Jump Ring and thread the Lobster Clasp onto it. Close the Jump Ring and twist open another. Thread this Jump Ring through the other, then through the Round Face Charm, then through a small Thin Hammered Ring. Close the Jump Ring.

Step 2. Using Jump Rings, attach a Thin Ruffled Ring to the last Hammered Ring, then attach another Hammered Ring to the Thin Ruffled Ring.

Step 3. Take the Round Half Ring and four Jump Rings. Open these Jump Rings and attach them to the outer edge of the Round Half Ring, spacing them out evenly. Place the Round Half Ring inside the Hammered Large Ring and attach the Jump Rings to the Hammered Large Ring. Twist all of the Jump Rings closed.

Step 4. Using a Jump Ring, attach this Large Ring to the chain of three smaller rings from Step 2. Attach a small Thin Hammered Ring, a Thin Ruffled Ring, and another small Thin Hammered Ring to the other side of the Large Ring to form the “chain” on the other side of the bracelet.

Step 5. Take three Eye Pins and string three Fancy Jasper Rounds onto two of the Eye Pins, and four Fancy Jasper Rounds onto another. Form a simple loop on each Eye Pin by bending the Eye Pin above the Rounds 90 degrees with Flat Nose Pliers. Trim the excess with Side Cutters to leave 3/8 inch behind, then curl this into a tight loop with Round Nose Pliers.

Step 6. Twist open the two Jump Rings attached to the small Hammered Ring on either side of the Large Ring, and thread the loops of the Eye Pin with three Rounds through each Jump Ring so the Rounds cross the Ring. Close the Jump Rings and repeat this on the small Hammered Ring on the other side.

Step 7. Gently open the loops on the Eye Pin with the four Rounds on it and attach these loops to the inner rim of the Round Half Ring Charm (you may have to bend the Eye Pin a little to make it fit). Close these loops with Flat Nose Pliers. Enjoy!