Materials used: 
19 Headpins (#50586) Qty: 
1 Spring Clasp (#50142) Qty:  
3 Jump Rings (#50040) Qty:  
101 4mm AB Clear Faceted Crystal Rounds (#16171-F) Qty:  
(abbreviated CR in these instructions) 
333 Clear AB Seed Beads (#J-721) Qty:  
2 Crimp Beads (#50046) Qty:  
22” Tiger Tail Beading Wire (#49013) Qty:  

Directions: 
To begin, make 19 “dangles” as follows.  Keep them in order as you make them.  Put on headpins, form small loop at the top, cut off excess. 
Middle, make 1: CR, 7 seed beads, CR, 7 seed beads, CR, 7 seed beads. 
2 each: CR, 6 seed beads, CR, 6 seed beads, CR, 6 seed beads. 
2 each: CR, 6 seed beads, CR, 6 seed beads, CR, 5 seed beads. 
2 each: CR, 6 seed beads, CR, 5 seed beads, CR, 5 seed beads. 
2 each: CR, 5 seed beads, CR, 5 seed beads, CR, 5 seed beads. 
2 each: CR, 5 seed beads, CR, 5 seed beads, CR, 4 seed beads. 
2 each: CR, 5 seed beads, CR, 4 seed beads, CR, 4 seed beads. 
2 each: CR, 4 seed beads, CR, 4 seed beads, CR, 4 seed beads. 
2 each: CR, 4 seed beads. CR, 4 seed beads. CR, 3 seed beads. 
2 each: CR, 4 seed beads, CR, 3 seed beads, CR, 3 seed beads. 
Lay out the dangles in order. 
Begin stringing the necklace as follows: 
Crimp bead, jump ring, wire back through crimp bead.  Close the crimp bead.  Leave about 1” wire. 
Thread: 1 CR, 7 seed beads; do this 12 times.  End with CR. 
Add dangle, CR, dangle, CR, until all 19 dangles are in place. 
Then: 1 CR, 7 seed beads; do this 12 times.  End with CR. 
String crimp bead, spring clasp, and back through the crimp bead.  Close the crimp bead. Trim off tail. 

Your necklace is complete!  You will look as good as Cinderella at the Ball!!