Spring Drop Earrings
Created by Michelle from our filling department, this decadent pair of earrings reminds us that Spring is right around the corner. The lush combination of Peridot Preciosa Bicone Crystals and Gold Plated Filigree is a vivid representation of the season. Pair them with your favorite sundress. The finished length measures approximately 2 ¼ inches, including the ear wire.

Materials: 
1 Pkg. Gold Plated Daisy Bead Caps (#14051) Qty: 
1 Pkg. Peridot Preciosa Bicone Crystals, 6mm (#42022) Qty: 
1 Pkg. Peridot Preciosa Bicone Crystals, 8mm (#42023) Qty: 
1 Pkg. Gold Plated Flat French Hook Ear Wires (#50005) Qty: 
1 Pkg. Gold Plated Jump Rings, 4mm (#50039) Qty: 
1 Pkg. Gold Plated Six Loop Filigree Chandelier Findings (#50509) Qty: 
1 Pkg. Gold Plated 1 inch Thick Head Pins (#50583) Qty: 
1 Pkg. Gold Plated 1 inch Thick Eye Pins (#50591)   Qty: 

Tools and glue you will need (change quantity to 1 if you need them):
Flat Chain Nose Pliers (#51016) Qty:   
Round Nose Pliers (#51017) Qty:   
Side Cutters (#51018) Qty: 

Directions:
Step 1. Thread one 6mm Crystal onto an Eye Pin. Form a simple loop above the Crystal by bending the Eye Pin 90 degrees with Flat Nose Pliers, then trim with Side Cutters to leave 3/8 inch behind. Curl into a tight loop with Round Nose Pliers. Slide one end through the loop on the Filigree. Twist open a Jump Ring and slide through the other end and then through the bottom loop on the Ear Wire.

Step 2. Onto two separate Head Pins, thread one 6mm Crystal. Form a simple loop above the Crystal and attach on the bottom outer loops of the Filigree.

Step 3. Thread one 8mm Crystal, one Bead Cap and one 6mm Crystal onto a Head Pin. Form a simple loop above the Crystal and attach to the bottom center loop of the Filigree.

Step 4. Repeat step 1-3 to complete the other earring. Enjoy!