Woodland Acorn Earrings
Our Vintage Acorn Bead Caps are perfect for this lovely fall time of the year. I combined our 12mm Red Jasper Gemstone Rounds along with our new Acorn Bead Caps and, to add a little sparkle I used our 4mm Crystal Copper Swarovski Bicones. The finished length measures approximately 1.5 inches, including the ear wire.   See them made with Honey Jade also.  -Allie, Customer Service

Materials: 
1 Pkg. Red Jasper Gemstone Rounds, 12mm (#11049-12) Qty: 
1 Pkg. Vintage Brass Acorn Bead Cap (#14804) Qty: 
1 Pkg. Crystal Copper Swarovski Bicone, 4mm (#16674) Qty: 
1 Pkg. Vintage Brass 2 inch Thick Head Pin (#50326) Qty: 
1 Pkg. Vintage Brass Jump Rings, 4mm (#50332) Qty: 
1 Pkg. Vintage Brass Rounded Loop Ear Wires (#50338) Qty: 
1 Pkg. Vintage Brass Corrugated Crimp Beads, 2mm (#50542) Qty: 

Tools and glue you will need (change quantity to 1 if you need them):
Flat Chain Nose Pliers (#51016) Qty:   
Round Nose Pliers (#51017) Qty:   
Side Cutters (#51018) Qty: 

Directions:
Step 1. Take a Head Pin and slide one Crimp Bead, one Red Jasper Round one, one Acorn Bead Cap, and one Copper Bicone.

Step 2. Form a simple loop above the Bicone by bending the Head Pin 90 degrees with Flat Nose Pliers. Trim the excess with Side Cutters to leave 3/8 inch behind, and curl into a loop with Round Nose Pliers.

Step 3. Twist open a Jump Ring and slide it through the loop of the Head Pin and through the loop of the Ear Wire. Twist the Jump Ring closed.

Step 4. Repeat steps 1-3 to create the second earring. Enjoy!